Baikal ij-70 makarov serial numbers

I bought one today in Wexford, I can not figure out how old it is. Here is some details Makarov Handgun Made. The Makarov pistol or PM. Large numbers of Makarov pistols are still in. Chuck Hawks shares information about the 9x18mm and. Live with it. In any case, keep the firing pin clean and lightly lubricated. If this still gives you the willies, you may have to carry it with no round in the chamber.

The only real safety you need is the one between your ears. Practice proper gun retention and basic safety and you shouldn't have any problems. SKS rifles are another story, although I suspect this is also largely due to, what we call in computer support, "user error.

You'll probably have to jar it pretty hard like drop it on its muzzle from 4 feet up to get it to go off. The state of California despite all its faults with respect to gun laws tested and approved the Makarov for safety including a drop test.

However, if you reload, make sure you seat primers below flush with the butt of the case. I inadvertantly used a 9mm shell holder when reloading, and the resulting primers were almost even just barely recessed with the head face.

The cross-sectional picture gives a better look at how the pistol is put together. Here are some more thoughts on the "drop worthiness" of the gun with respect to the firing pin from a reader:. I have conducted my own drop tests using my Mak 9 mm hi-cap model manufactured by Imez and imported by KBI.

Although not scientifically done, I am satisfied that my firearm, at least, won't discharge by dropping. I removed the ball from a 9mm Mak round manufactured by Cor-Bon, emptied the propellant, but retained the primer.

I then cleaned the bolt repeatedly with solvent until the firing pin would move back and forth easily. A drop of oil was added and movement was again affirmed. The floor was a pine board to protect the firearm as well as the real floor, and the firearm was dropped times, per the CA test.

The drop height varied from table top to ten feet. The primer round was in the chamber and the safety was engaged. Twenty-three of the drops resulted in the firearm landing slightly askew as its center of gravity made muzzle drops from more that three feet difficult. Nevertheless, of the successful drops not one resulted in so much as a mark on the primer cap. This is probably due to the low velocity of the drop at such minor heights, but I suspect that the minuscule mass of the firing pin and the fact that it can only travel about three millimeters at best precludes sufficient energy transfer to impact the primer.

Anyway, I feel confident that my gun, at least, is safe for carry. I have talked to a number of Mak owners since my first email, and no one has heard of such a faulty discharge.

Common Model paint in bright colors can be used to enhance your stock Military sights, or even the newer Glow in the Dark paints can be used for a "Poor Mans Night sight", however these are prone to wear, and will fade fast. Beyond that, you'll have to spend some money.

However, the difference in sight picture can be amazing. If you have a Makarov with fixed rear sights and want something easier to spot, Makarov. Many gunsmiths still do this type of work, contact a local gunsmith in your area for more information and pricing.. By all means, get one in the original caliber of 9x18 Makarov, unless you are already familiar with the.

In fact, you can often get surplus 9x18 Makarov ammo cheaper than. Note that you can now buy aftermarket replacement barrels in both 9x18M and. So if you made the unfortunate mistake of buying a.

Also, if you have. Changing a barrel requires some mechanical skill and we highly recommend a barrel press. Barrel replacement is not a simple procedure, but can be done by mechanically inclined people.

My general rule of thumb is that if you can change the oil on your car, you can do this. Read more about how to do this here. You will need to completely disassemble the gun in order to be able to press the barrel out.

We have a complete disassembly instruction page here. There are those that disagree with me including an author of an article in Handguns magazine and gun dealers who wants to sell you a Makarov. The 9x18M cartridge is not a "true" 9mm because it's really 9.

Therefore the bullets are sized. Yes, you can probably get away with it a few times, but accuracy will suffer, you'll get gas blow-by, your barrel will wear out faster and for what? Save a few pennies? If you absolutely want to shoot. For a car analogy, have you ever seen or owned a car that burned oil? How long did the engine last after it started blowing blue smoke? Probably not long.

The reason is that the pistons and rings are now smaller than the cylinders and each explosion sends gasses by-passing the piston "blow-by". You're literally burning the sides of your pistons now and engine death is imminent. That's basically what you're doing by shooting undersized bullets.

This is even worse than the other way around. The bullet is too big. Really, 9x18M Makarovs are not that expensive You can also change the barrel and you gun will now fire 9x18M. And if you want more power, get a.

Holy smokes Kill yourself?!? Look, fire. Fire 9x18 M from a 9x18 M pistol. Fire 9mm Parabellum from a 9mm pistol. It's that simple. If you want multi- calibers, get a. According to the director Russian Affairs at former importer B-West, they tested the 9x19 Makarov available from Baikal. The way the 9x19 Makarov works is that the chamber is scored or serrated, the brass gets blown out into those serrations thereby retarding blowback.

The result is that the brass is shredded and unusable for reloading, the brass is tossed into low orbit, and the recoil of the gun is horrendous.

For liability reasons, B-West refused to import these. Similarly, reaming the chamber of a. Naturally, if you want to shoot only handloads and know what you're doing while working up a load, you can try this. I suggest a good life insurance policy first though. Like with. Don't do it! Best for what? We make i. Some shooters have reported problems extracting Blazers, but they work fine for others. Note that Norinco and some other surplus rounds have steel jacketed bullets and thus are often prohibited at indoor ranges.

Some of the Russian TCW is pretty hot and we recommend changing to a 19 recoil spring. The new Silver Bear has promise, but many people report feeding problems.

Again, with any of these high-performance rounds, you might want to consider a stronger Wolff Gunsprings 19 recoil spring the original is Of course, the best and cheapest place to get ammunition is from your own reloading press. Think about reloading 9x18M. There are others such as 9mm Ultra, 9mm Police, 9x21, 9mm Largo, etc. Note that none of these, except those with equal signs, are the same things. If you mean 9mm Parabellum also called 9mm Luger - no.

It is not a true 9 mm. The most common is 9mm Parabellum- also known as 9mm Luger or 9x No- two different cartridges.

They are for different guns and do not interchange. The 9x19 is also the 9mm Parabellum or 9mm Luger- the 9x18 is the 9mm Makarov. To answer your question, we need the make and model of tthe pistol. There are some pistols that do not have a hi cap mag, and not all mags work in all pistols. The value of a Browning 9mm serial number a depends on its condition.

This gun in excellent condition is valued between That's the only cartridge that gun can fire.